Stihl FG 3 Instrucciones De Servicio página 17

10
4
10
:
Rotate the knurled nut (8) to move
stop (9) up against the back of the
cutter to be sharpened.
FG 3
4
9
:
Now rotate the knurled nut a little
more until the side plate presses
against the file and the stop bar (10)
is lifted about 0.1 to 0.2 mm off the
stop roller (4).
Sharpening
8
2
1
:
Sharpen the master cutter with 2 to
3 firm strokes of the file. Always file
from the inside to the outside of the
side plate.
:
The stop bar (1) should now locate
against the stop roller (2).
If this is not the case, readjust the
stop (3) slightly and pull the chain up
against it. Check the position of the
stop again.
english
2
1
3
17