GYS WF 50 Manual De Uso página 126

Using the machine interface
To unwind the wire in the MIG/MAG torch without using gas, please follow the procedure below:
1- Hold the trigger down in a non-welding position.
2- When the process is shown on the display, you can release the trigger.
3- The wire starts to feed. 3m of wire feeds at a speed of 5m/min by default. You can change these va-
lues with the thumbwheel.
If you wish to exit the animation without waiting for the wire to finish feeding, press the trigger briefly.
Job memory and recalls
Accessible through the «JOB» icon on the main screen.
The settings in use are automatically saved and remembered the next time you turn on the machine.
In addition to the active settings, it is possible to save and recall «JOB» configurations..
There are 200 JOBS for the MIG/MAG process and 100 for the TIG and MMA process. The storage is based on the current pro-
cess parameters, and the current settings.
Job
This JOB mode allows you to create, save, recall and delete JOBs.
1- Save As - Creating a Job
Customise the job name. Confirm by pressing push-button no. 4 (
Display the current job
At the bottom right of the screen, the job number is displayed.
Stop the current job
To close the current job, the user must return to the Job menu and select «Close».
2- Open - Jobs Management
The left-hand side of the screen lists previously created jobs.
Short presssing push-button no. 1 returns to the previous menu
A short press on the push-button n°2 allows to sort these Jobs by name or by date.
Holding down push-button no. 2 ( ) deletes the active job or all jobs.
On the right hand side of the screen you can see the details of all previously created jobs with the following information:
Wire diameter, thickness, tension, etc..
A short press on push-button no. 3 ( ) allows the active job to be assigned to other users or only to the administrator.
A short press on push-button no. 4 (
QuickLoad – Recall JOBs from the trigger when not welding.
QuickLoad is a mode to recall jobs outside of welding, and is only possible in MIG-MAG and TIG processes.
22
) loads the active job.
).