Publicidad
Idiomas disponibles
Idiomas disponibles
4
Installation and adjustment
The patient hoist is delivered fully assembled by your specialist dealer.
The instructions in this chapter are for the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
WARNING: Risk of unsafe limitations - Use only the limitations described in this
L
manual.
4.1
Delivery
The Vermeiren Falcon patient hoist shall be delivered with:
• chassis including 4 casters (2 with brakes)
• pole, including handles for pushing
• cantilever arm and spreader bar
• control box (incl. 2 accumulator batteries and manual operation)
• battery charger
• motor
• instruction manual
Before use check if everything is included and that no products are damaged (example by
transport, ...).
Please note that the basic configuration may vary from one European country to another. Please
contact the specialist dealer in your country for more information.
4.2
Assembly or dismantling
4.2.1 Unpacking
WARNING: Risk of injury - After unpacking and before further assembly, always first
L
confirm that the emergency stop (the red pushbutton on the control box) is pressed in.
The patient hoist packaging has been selected to provide the best possible protection during
transport.
1. Take all parts of the patient hoist out of the box and check
that all the items have been delivered and that the individual
parts do not have any visible defects. If there is any damage,
please contact your sales office.
2. Before assembly, put on the caster brakes to make sure that
the lift cannot be moved unintentionally. Push the caster
brake plate down gently to its end stop with the front of your
foot. To release the brake, push the brake plate gently back
up again with the front of your foot until the caster is free.
11
Falcon
2022-11
Installation and adjustment
EN
NL
Publicidad
