Publicidad
Idiomas disponibles
Idiomas disponibles
EN
NL
4.2.2 Assembly
WARNING: Risk of clamping - Take care that no body parts and wires
L
get trapped, crushed or cut during assembly.
1. Insert the vertical pole into the lower frame and tighten the lever securely.
2. Place the motor in its attachments on the vertical pole and the hoist arm
(4) and secure into place with the pins.
3. For first use: Mount the control box to the vertical pole by tightening the
two bolts.
4.2.3 Dismantling
WARNING: Risk of clamping - Take care that no body parts and wires
L
get trapped, crushed or cut during dismantling.
WARNING: Risk of injury - Check the emergency stop (red
L
pushbutton on the control box) is activated, to avoid unintentional
adjustment movements.
1. Secure the two casters at the back of the chassis by pressing the caster
brake plates down gently to their end stops with the tip of your foot. To
release the brake, push the brake plate gently back up again with the
front of your foot until the casters are free.
2. Release the motor from the hoist arm and vertical pole by removing the
pins (4).
3. Remove the lever and take the vertical pole out of the lower frame.
12
Falcon
2022-11
Installation and adjustment
4
3
4
3
Publicidad
