Anatomical Seat; Anatomical Back; Pushbar - Vermeiren Eclips XXL Manual De Instrucciones

EN
NL
3.4

Anatomical seat

CAUTION
 Check that the seat is firmly secured before use. Check that the screws are not damaged.
 Avoid getting your fingers caught during the assembly process (between seat and cross-hinge).
3.5

Anatomical back

CAUTION
 Check that the backrest is firmly mounted into the four brackets before using your wheelchair.
 Avoid getting your fingers, clothes caught during the assembly process.
3.6

Pushbar

CAUTION
 Make sure that all screws are properly tightened with the appropriate tool.
 When equipped with the push bar, the push bar shall always be mounted (→ to increase the
stability of the back).
Risk of injuries
Your wheelchair has an anatomical padded seat, place it on the
tubular cross-hinge so that the seat's supports engage equally
with the cross-hinge. In the wooden base you will find slots that
are placed in the hinge's cross-pieces. To fold up the wheelchair,
remove the seat by pulling it upwards.
Risk of injuries
The backrest of the wheelchair can be mounted by
following instructions.
1. Mount the backrest into the four brackets .
2. Turn on the upper star buttons  to lock the star
buttons by hand.
3. Check that the backrest is firmly fixated.
To remove the backrest of the wheelchair:
1. Loosen the upper star buttons ➁.
2. Pull the backrest upwards out the four brackets .
Risk of injuries
The push bar will be delivered for some seat widths.
The push bar increases the stability of the back and
offers the possibility for an attendant to push the
wheelchair. To do this, use the pre-mounted handles.
As there are different push bars for different seat
widths, take care that no tension is created between
the push handles of the back tubes.
8
Eclips XXL
2023-01
Using your wheelchair