Remote Operation - Allen + Roth ARFPDF32F1 Manual Del Usuario

The system is operated manually from the remote and operates on radio frequencies (RF) within a 20-foot
range using non-directional signals. The remote receiver's code must be matched to the transmitter's
code prior to initial use.
Learning the Remote to the Receiver:
Upon first use, you must press the "LEARN" button on the receiver to synchronize the remote. This process
must be repeated if you replace the batteries or purchase a replacement remote. The slide switch on the
receiver must be in the REMOTE position. If the slide switch is in the ON or OFF position, the receiver will not
synchronize with the remote. The "LEARN" button is located on the front face of the receiver, inside the small
hole labeled "LEARN." Press and release the black "LEARN" button inside the hole—a paper clip or small
screwdriver works best, and press any button on the remote. When the "LEARN" button is released, the
receiver emits a beeping pattern.
The "LEARN" procedure uses a timing function. If the remote is not synchronized with the receiver on the first
attempt, wait 1–2 minutes and try again, which allows the timer to reset. Follow this procedure 2–3 times if necessary.
NOTE: Review COMMUNICATION SAFETY under the GENERAL INFORMATION section. This safety feature
shuts down the appliance during potentially hazardous or unsafe conditions.
Using the battery power from the receiver, the solenoid circuit operates a solenoid. The circuit uses
reversing polarity software to reverse the positive (+) and negative (-) output of the receiver's battery
power, which drives a latching solenoid ON/OFF. The system is controlled by the remote, which operates
on two (2) 1.5 V AAA batteries.
Always use ALKALINE batteries for
longer battery life and maximum
performance. Do not use rechargeable
batteries. Before using the remote,
place the two (2) AAA batteries in the
battery compartment.
batteries are placed in the proper
direction.
Remote Control Operation
LCD
ON
Ensure the
BUTTON
OFF
BUTTON
MODE
BUTTON
ON Turns the heater ON. Manually operated solenoid ON.
OFF Turns the heater OFF. Manually operated solenoid OFF.
MODE Changes the heater from manual mode to thermostat mode.
Sets the temperature in thermostat mode.
Fig. 25—Remote/Transmitter
UP
BUTTON
DOWN
BUTTON
Key Settings
26
Vent-Free Gas Fireplace User's Manual
WALL CLIP
SLOT
BATTRY
COMPARTMENT