General Information - Allen + Roth ARFPDF32F1 Manual Del Usuario

Ocultar thumbs Ver también para ARFPDF32F1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GENERAL INFORMATION

Communication/Safety/Remote
Built into the remote control's software is a COMMUNICATION/SAFETY function. It provides an extra
margin of safety when the remote is out of the normal 20-foot operating range of the receiver. The
COMMUNICATION/SAFETY feature operates the same in all operating modes.
In all operating modes and at all times, the remote/transmitter sends an RF signal every 15 minutes to the
receiver. This indicates that the remote/transmitter is within the 20-foot normal operating range. If the
receiver doesn't receive a signal from the remote every 15 minutes, the software in the receiver will begin a
2-hour countdown timing procedure. If the receiver does not receive a signal from the remote in this time,
the receiver shuts off the heater. The receiver then emits a series of beeps for 10 seconds. After these 10
seconds, the receiver continues to emit a single beep every four (4) seconds until either the ON or MODE
button on the remote is pressed, which resets the receiver. The 4-second beeping goes on for as long as
the receiver's batteries last.
To reset the receiver and operate the heater, press the "ON" or "MODE" button on the remote. When the
system is turned on, the COMMUNICATION/SAFETY beeping stops and the system returns to normal
operation based on the MODE selected on the remote/transmitter. The COMMUNICATION/SAFETY feature
restarts if the remote is taken out of the normal operating range or the remote's batteries fail or are
removed.
Childproof Feature:
The remote control includes a CHILDPROOF "LOCK-OUT" feature, letting the user "lock-out" operation of the
heater from the remote.
To use the "LOCK-OUT" feature, do the following:
• To activate the "LOCK-OUT" feature, press and hold the "ON" button and the "MODE" button at the same
time for five (5) seconds. The letters "CP" display in the TEMP frame on the LCD screen.
• To deactivate the "LOCK-OUT," press and hold the "ON" button and the "MODE" button at the same
time for five (5) seconds and the letters "CP" disappear from the LCD screen. The remote then returns to
normal operation.
• To verify remote is in the CP lock-out mode, press any key and the LCD screen shows "CP."
Remote Control Operation (cont.)
30
Vent-Free Gas Fireplace User's Manual

Publicidad

Tabla de contenido
loading

Tabla de contenido