Allen + Roth ARFPDF32F1 Manual Del Usuario página 28

Fig. 29—Thermostat Function
THERMOSTAT SET
THERMOSTAT ON
NOTE: The highest set temperature is 99° F
(32°C) and the lowest temperature is 45°F (6°C).
Notes on Operation:
The heater is operated by the thermostat feature whenever the room temperature varies a certain number of degrees
from the set temperature. This variation is known as "temperature differential" or "swing." Based on how well your
home is insulated from the cold, the normal operating cycle of the heater may be 2–4 times per hour. The "swing"
comes preset from the factory at 2, which allows for a temperature variation of +/- 2°F (1°C) between the set
temperature and the room temperature. This determines when the heater will begin operation.
To activate the ON and OFF manual functions on the remote, press either button on the face of the remote.
When "OFF" is pressed the valve and flame shuts off. When first used, a delay of three seconds may occur before
the receiver responds to the remote, which is normal.
Remote Receiver:
The remote receiver (see Fig. 30) operates on four (4) 1.5V
AA-size batteries. Always use alkaline batteries for longer
battery life and maximum performance. Always use new/
fully charged batteries for proper operation of the remote
receiver—the power consumption of a latching solenoid
is much higher than standard remote control systems. Do
not use rechargeable batteries.
NOTE: The remote receiver only responds to the remote
when the 3-position slide button on the remote receiver
is in the REMOTE position. The remote receiver contains
the microprocessor, to which the remote sends signals
for operation.
Remote Control Operation (cont.)
THERMOSTAT MODE
THERMOSTAT OFF
Thermostat Function (see Fig. 29):
This remote control system can be thermostatically controlled
when the control is in the A mode.
SETTING/CHANGING THE DESIRED ROOM TEMPERATURE
To set the THERMOSTAT MODE and the desired room temperature:
1. Press the MODE button to switch to Thermostat "A"
function.
2. Press the "∧" and "∨" buttons choose the desired set
temperature. Each time you press "∧" and "∨", the
temperature changes by 1 degree.
3. If the adjusted temperature is lower than the room temperature,
the flame icon is off and the valve and burner flame shuts off.
4. If the adjusted temperature is higher than the room temperature,
the flame icon is on and the valve and burner flame turns on.
REMOTE RECEIVER
BATTERY
COMPARTMENT
28
Fig. 30—Remote Receiver
LEARN BUTTON
VALVE/FLAME OFF
REMOTE SETTING
Vent-Free Gas Fireplace User's Manual
VALVE/FLAME ON