Publicidad
Idiomas disponibles
Idiomas disponibles
Review this table to find do-it-yourself solutions for minor performance problems. Any
service needed, other than maintenance described in this Use & Care G uide, should be
performed by a qualified service agent.
WARN IN G
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury.
PROBLEM
Unplugged at wall outlet.
The O n/ O ff button is not pressed
to start the vacuum cleaner.
Vacuum cleaner
Defective wall outlet.
won't run.
The vacuum body is overheated.
The motor is damaged.
The hose and attachments are not
installed correctly.
Dust bag is not installed correctly.
Full or clogged dust bag.
There is a clog in the air path.
Poor job of dirt
Suction control is in open position.
pick-up.
The foam filter or HEPA media
exhaust filter needs to be cleaned
or replaced.
The hose is worn.
The brushroll is worn.
Dust escapes
Dust bag or dust bag chamber
from vacuum.
cover is not installed correctly.
TROUBLESHOOTIN G
POSSIBLE CAUSE
Plug in firmly, press the O n/ O ff button.
Press the O n/ O ff button to start the vacuum
cleaner.
Check with a good appliance or lamp. Have
outlet properly serviced.
Unplug the power cord and let the vacuum
cool down for 50 minutes.
Call 1-844-60 8-30 80 (US) / 1-844-60 8-30 81
(CA) for assistance.
Check the hose and attachments for correct
installation and ensure they are snapped
firmly in place.
Check dust bag for correct installation and
ensure it is snapped firmly in place.
Change the dust bag (page 19-20).
Check and remove all clogs. Follow instructions
on page 23-24.
Adjust the suction control to increase suction.
Follow instructions on page 17.
Clean or replace the foam filter or HEPA
media exhaust filter. Follow the foam filter
cleaning or HEPA media exhaust filter cleaning
instructions on page 20-21 or 21-22.
Replace the hose assembly. To purchase parts,
call 1-844-60 8-30 80 (US) / 1-844-60 8-30 81
(CA).
Call 1-844-60 8-30 80 (US) / 1-844-60 8-30 81
(CA) for assistance.
Check the dust bag or dust bag chamber
cover for correct installation and ensure they
are snapped firmly in place. Follow instructions
on page 19-20.
- 25 -
SOLUTION
Publicidad
