ROTOR ROT112 Manual De Usuario página 36

4. FIXING OF NON-DRIVE SIDE ASSEMbLy
4.1. Tighten drive side alloy bolt to 35 Nm using an
8mm allen torque wrench.
5. pRELOAD ADJUStMENt
5.1. Eliminate lateral play by tightening
counterclockwise the preload nut by hand.
5.2.
Lock the preload nut by tightening the pinch bolt
clockwise with a 2 mm allen wrench.
WARNING!
36
35 Nm
Do not overtighten the bolt
USER MANUAL - CRANK INSTALLATION
6. FINE tUNE ADJUStMENt
6.1. If the crank does not turn smoothly, remove the
0,5mm plastic washer in non-drive side and repeat
the "preload adjustment" steps 5.1 and 5.2.
6.2. If there is lateral play, use an additional 0,5mm
plastic washer in the non-drive side and repeat
the "preload adjustment" steps 5.1 and 5.2.
WARNING!
Ensure preload
nut is still threaded
in non-drive side
arm.