Calibration/Zeroing - ROTOR ROT112 Manual De Usuario

AUtOMAtIC pAIRING
3. Push the "SCAN" button in your ANT+
the ANT+ Power screen. The "SCAN" button is
TM
usually placed in the menu: Settings\Bike settings\
Bike profiles\"Your profile"\ANT+ Power.
MANUAL pAIRING
If you have more than one ANT+
introduce the "SENSOR ID" of the ROTOR Power
into the ANT+ device; "SENSOR ID" can be
TM
found at the inner side of the drive side crank as
the last 5 digits of the shown number or in your
Identity Card included into the package.
I.E.: SENSOR ID_ 02310
SENSOR
ID_ 02310
USER MANUAL - PAIRING/CALIBRATION

CALIBRATION/ZEROING

device at The main reason to calibrate / zero your ROTOR Power
TM
is to secure an exact power measurement.
Calibrating the power meter compensates for any
mechanical change that influences the measurement
since the last calibration/zeroing.
Calibrate your ROTOR Power cranks after the
assembly process in your bicycle with all its
Power sensor
TM
accessories, pedals included.
ROTOR Power should be calibrated after any
chainring, frame, or pedal changes. After every
calibration process ROTOR Power shows one second
flash at the red light LED.
PRODUCT ID CARD
In order to save energy the "CALIBRATE"
SENSOR ID
02310
command is admitted only within 60 seconds
QC DATE
from startup or last valid power readings.
Register your ROTOR Power at power.rotorbike.com/registration
www.rotorbike.com
WARNING
ES
EN
39