Volvo Penta IPS Dynamic Positioning System Instrucciones De Montaje página 6

9.
1
Push the bolt (4) with washer (5) through the tripod (D)
and install the washer (6) and nut (7) from below. Fasten
the DPS antenna.
NOTE! Seal all bushings with marine sealant.
IMPORTANT! At the base of the DPS antenna there is an
arrow. This arrow must always point towards the bow (see
4
illustration).
5
D
6
7
10.
Tighten the union nut (A) on the cable bushing with a
23 mm open end wrench.
NOTE! Do not tighten the union nut too hard.
Refer to Connecting connectors before connecting the
DPS antenna to the EVC system.
Foldable, removable targa bar, antenna mast
If the DPS antenna is installed on a foldable installation,
the connection must be flexible. There must be sufficient
cable slack. Refer to illustration.
NOTE! Be careful to secure the cable with sufficient flexi-
bility (slack) to ensure correct function.
6