Fagor PS-50/200 TP2 Manual De Instrucciones página 23

- Fan motor power:
- Extraction rate:
- Head loss at fan outlet:
The extra extraction motor must be coupled to the machine to start at the same time as the
machine's ventilation motors. An auxiliary NO contact is available on contacts KV1 and KV2 to
manage this coupling.
•
If the machine is equipped with a back outlet, it is strongly recommended to
cover the evacuation ducts with heat insulation.
2.2.8. Commissioning
Before commissioning the machine, remove the transport brackets which hold the
cylinder during transport from the manufacturing plant.
Raise the upper panels (see section 4.2) to access the transport brackets on each side of the
machine shown circled below. Simply unscrew the screws holding the transport brackets to
remove them. Keep them for reuse if the machine is to be transported again in the future.
After making sure that the machine is installed according to the recommendations in this
manual (levelling, electricity, gas or steam connection depending on the model, removal of the
transport brackets), start up the dryer ironer:
0.25 KW
3
600 m /h
60 Pa
19