Publicidad
Idiomas disponibles
Idiomas disponibles
•
Turn the cut-off switch at the back of the machine on the left side to position 1.
•
Check that the emergency stop button has not been triggered
•
Open the GAS or STEAM valve (very gradually) if applicable.
•
Press START to remove the wax paper wrapped around the cylinder.
•
Make sure that the feelers are in the correct positions before and just after the 1
of the machine as they could be mispositioned due to the paraffin wax applied in the
factory to protect the cylinder from corrosion (see section 4.5).
•
Check that the machine is working properly (in the event of any anomaly, refer to
section 5).
•
Make sure that the fan motors rotate in the correct direction (see the direction of the
arrow on each fan motor).
•
Train the operating personnel in the use of the machine as described in section 3.
st
start
20
Publicidad
