cecotec bolero DRESSCODE 121000 STEEL Manual De Instrucciones página 30

ENGLISH
Note:
- You must calibrate the washing machine before using it.
- Before the first wash, run a first cycle without laundry (i.e., with an empty drum) at low
revolutions.
3. PRODUCT INSTALLATION
1. Place the washing machine on a stable, flat, and dry surface. Make sure the product does
not crush the power cord. Avoid direct sunlight and ensure sufficient ventilation. Fig. 3
2. Make sure all extruded polystyrene packaging has been removed. Lift the washing
machine and remove the base packing. Make sure the small triangle foam is removed
along with the bottom one. If not, carefully position the washing machine sideways and
remove it by hand. Fig. 4
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the water supply hose from the drum.
Removing the transport bolts
- The transport bolts must be removed from the back of the washing machine before using
the washing machine.
- Store the transport bolts in a place they can be easily retrieved from in case of future
displacement of the washing machine.
- To remove the transport bolts, follow the steps below:
1. Loosen the 4 bolts with a spanner and then remove them. Fig. 5
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Levelling the washing machine Fig. 6
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
1. Loosen the lock nut.
2. Rotate the leg until it reaches the ground.
3. Adjust the leg height. Make sure the washing machine is level and fix the lock nuts.
Water supply hose connection
Connect the water supply hose following the steps below:
1. Connect the water supply hose to the washing machine's water inlet valve as shown in
Figure 7.
2. Connect the other end of the water supply hose to a suitable tap as shown in Figure 8.
BOLERO DRESSCODE 121000 STEEL
58
Note:
- Do not twist, crush, or modify the water supply hose.
- Connect the water supply hose manually. Do not use tools.
- Check that the water hose is correctly installed.
Drain hose
There are two ways to place the end of the drain hose:
- In a drainpipe. Fig. 9
- In a sink's drainpipe, over the trap. Fig. 10
Warning
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
- When installing the drain hose, fix it properly. If drain hose is too long, do not force it into
washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operating it.
- This washing machine was test-checked before leaving the factory. To remove possible
water residues and odours resulting from these tests, we recommend you run a complete
cycle without laundry at low revolutions before the first wash.
Calibration
The device can detect the amount of laundry loaded. This feature optimises performance
by minimising energy and water consumption, saving money and time. For this reason, it is
recommended to calibrate the device for best use.
1. Make sure the inside of the drum is empty and close the door.
2. Plug the washing machine to a mains socket.
3. Turn on the washing machine and press [
until the display shows "t19".
4. Press [ ] to start up the washing machine and wait until the display shows "****".
Using the washing machine
Fig. 11
1. Plug the washing machine to a mains socket.
2. Open the water supply tap.
3. Put the items to be washed into the washing machine.
ENGLISH
]and [ ] simultaneously for 10 seconds
BOLERO DRESSCODE 121000 STEEL
59