Beper 40.740 Manual De Instrucciones página 14

Rechargeable hair clipper Use instructions
LED LIGHT FUNCTIONAL DESCRIPTION:
It can be placed upright and charged when inserting into the base.
Explanation on charge and discharge
LED shows battery capacity (number displayed:00/05/10/15/20/25/30/35/40/45/50/55/60).when
shows 05,the indicating light will be turns to red from blue. The charging battery has only 5%, needs
charge ( Figure2)
If the clipper is stopped for no electricity, connect the adapter to the unit for continuous use ;please
do not operate for long time, or it may burn the adapter.
( Figure2)
OPERATION
For best cutting performance
The hair to be cut must be dry and clean
Before operation, the cutting head should be oiled alway. For this, use the supplied blade oil.
Put the attachment comb required on the cutting head, The adjustment attachment comb permit 6
position cutting length from 4to 30mm. (see illustrations above). Start with the largest position cut-
ting length first. And, if necessary, use a position shorter one.
Switch the appliance on by moving the ON/OFF switch upwards ("ON" position). We recommend to
trim a small area first to familiarize yourself with the attachment comb.
Move the trimmer upwards and out wards through the hair, a little at a time, against the direction of
hair growth.
The appliance will work most efficiently when cutting through the hair at its own speed. Never force
the trimmer through the hair. Never switch the trimmer off whilst in the hair.
For longer hair on top of the head, use the long comb and lift hair on top of the head, cutting over
the comb, or hold the hair between the fingers and cut to the desired length. Always work from the
front to the back of the head.
To outline
Do not attach a attachment comb
Hold trimmer upside down and holding it gently against the skin at the length desired, move
downward.
Having defined the outline, gently hold the trimmer against the skin, the teeth of the trimmer pointing
up wards and move the trimmer upwards against the direction of hair growth to the defined outline.
This will trim the unwanted hair adjacent to the outline.
CHARGING
The best environmental temperature for changing is between 15°C and 35°C.
Using the Switching adaptor, connect the clipper to an electrical outlet with the motor switched off.
The LED light shows that the clipper is being charged. When the batteries are charged, you can see
the writing 60 min. Go ahead disconnecting the unit from the power.
Maximum battery capacity will only be reached after several charging/discharging cycles.
When charge the unit, it can be used to cut the hair.
14