Steelcase Migration SE Instrucciones De Uso página 42

5 Operating and adjusting
Resetting to factory settings
EN
Scan me! : Factory Reset Aninmation
The following procedure for deactivating/activating
the LOGICisp sensor may only be carried out by
qualified personnel such as the facility manager!
Deactivating/ activating the LOGICisp sensor
42
=
The table is at the lowest position.
1. Press the "Up" button.
ü The system has now been reset to the factory
settings.
1. Press the "1" and "2" and "Up" buttons and hold
for 5 seconds.
=
The letter S and a number (e.g. S4) are shown on
the display.
2. Press the "Up"or "Down" button until S3 is shown
on the display.
=
The display indicates S3.