Steelcase Migration SE Instrucciones De Uso página 46

6 Errors and faults
Some faults that could occur are indicated for the Up/Down
control panel on the LED signal lamp, and for the Memory
control panel on the display.
The tables below should help you to determine the cause and
correct the error or fault.
6.3 Error messages
The tables below should help you to determine the cause and
correct the error or fault.
6.3.1 Table of error messages with the Up/Down
control panel
Signal/Code
Lamp not lit
EN
Flashing red
46
Message Required measure(s)
Normal system The DM system can be used
operation as usual
The system is not Instructions on how to
correctly connected correctly connect the system
can be found in the DM
system manual
Warning - System Release all buttons and wait
error 5 seconds. Then try to
repeat the action.
Disconnect the DM system
from the power supply.
(If a power lift is used)
disconnect the power lift
from the mains. Check the
power supply system for
overheating. Let it cool if
required. Check all cable
connections and re-connect
the system.
Should the problem persist:
■ Perform a "manual reset".
■ Contact LOGICDATA.