Steelcase Migration SE Instrucciones De Uso página 48

6 Errors and faults
Signal/Code
C2
C11
C13
C17
EN
C19
C22
48
Message
Overcurrent with
motor
Speed cannot be
reached.
DC undervoltage.
Error with pairing.
Too many or too few
drive units are
connected.
Overload of power
supply.
Required measure(s)
Release all buttons and wait
5 seconds.
Then try again.
Release all buttons and wait
5 seconds.
Then try again.
Release all buttons and wait
5 seconds.
Then try again.
Disconnect the power
supply from the mains
connection.
Then disconnect the system
from the power supply. Re-
connect the system and use
it as usual.
If this is not possible,
perform a reset to the
factory settings.
Connect the correct number
of drive units (as specified
under Setup).
Release all buttons and wait
5 seconds.
Then try again.