Kemper 79 205 Instrucciones De Servicio página 56

WARNING
Falls and falling components cause serious injuries.
Only use standard ladders, e.g. working platforms.
Only use suitable lifting equipment.
Never stand under suspended loads.
The assembly must only be carried out by two persons.
5.1 Assembly requirements
• Mount the cantilever arm for the product only on suitable walls and
columns.
• Only use the supplied mounting material and recommended fixings.
• Observe the tightening torques of the screws.
5.2 Load-bearing capacity of the wall mount bracket due to
the extraction arms
Extraction Note
arm
length
4 2 m cantilever arm
+ 2 m extraction
arm
5 2 m cantilever arm
+ 3 m extraction
arm
6 2 m cantilever arm
+ 4 m extraction
arm
7 3 m cantilever arm
+ 4 m extraction
arm
1502760-03
Torque on wall
mount bracket
[Nm]
(rounded values)
3200
3260
3360
6410
Tab. 20: Load table
- 56 -
Tensile force per
upper fastening
screw
(rounded values)
[N]
5160
5250
5500
10350
EN