Wurth Master PBS 120 Instrucciones De Servicio página 14

Device components
Before using the metal saw, the operator must familiar-
ise himself with all device features and the applicable
safety instructions.
Machine overview (Fig. I – VI)
1 Machine frame
2 Vice screw with clamping lever
3 Vice
4 Saw band
5 Hand wheel for the adjustment of the saw band
tension
6 Switch
7 Handle
8 Swivelling housing
9 Clamping lever for saw band guide
10 Adjustable saw band guide
11 Rotary controller for motor speed
12 Motor
13 Main motor switch
14 Swivel bearing
15 Locking pin
16 Clamping lever for mitre cutting
17 Adjustable stop
18 Clamping screw for stop
19 Guide rod
20 Lock nut
21 Cap nuts
22 Stop
23 Stud
24 Stop
25 Adjusting knob
26 Release knob
27 Securing bolts for guard
Metal saw data
Type
Prod. no.
Rated voltage
Rated frequency
Max. current consumption
Rated input power
Speed
Protection class
Weight
Dimensions (W x L x H) max.
Dimensions of saw blade
14
This machine has been designed and produced ac-
cording to the latest technology and meets the typical
requirements for the cutting of metal in an industrial or
workshop environment.
It can be used to cut the following materials:
The saw is not suitable for the cutting of:
Swivel the housing 8 to its lower stop and insert the
locking pin 15 into the respective borehole.
–
–
–
–
PBS 120
–
0701 320 X
230 V AC
50/60 Hz
5,0 A
1,200 W
8,000 - 16,000 rpm
/ I
approx. 18 kg
850x830x600 mm
1,440x13x0.65 mm
Proper use
• Standard steel grades (St37, St50, ...)
• Special steel grades (C 40, 18NiCrMo5 ...)
• Aluminium and aluminium alloys
• Brass
• Bronze
• Steel pipes (St 35, ST 52 ...)
• Timber and similar soft materials
The saw is designed for dry cutting
only.
The use of cooling lubricant might irrep-
arably damage the saw.
Transport (fig. II)
To transport the machine, ensure that no
workpiece is clamped in it and that the
locking pin 15 is properly engaged!
Workplace
Place the metal saw onto a level workbench and
secure it against tipping.
IIdeally, the vice should be about 90 to 95 cm
above the floor.
Secure the machine to the workbench by inserting
screws through the provided boreholes in the ma-
chine frame 1.
When securing the saw with a C-clamp, place the
clamp onto the provided area at the centre of the
machine frame 1.
Ensure that your view is not obstructed during working.