Publicidad
Idiomas disponibles
Idiomas disponibles
Disposal
Dispose of the electrical tools, accessories and packag-
ing material in an environmentally friendly manner for
recycling, where this is possible.
For EU member states only:
Do not dispose of electronic tools
through the domestic waste collec-
tion.
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment (WEEE), electric tools must
be collected separately for recycling.
Warranty
This WÜRTH metal saw is covered by warranty accord-
ing to the applicable national regulations. The warran-
ty period begins on the date of purchase (please retain
invoice or delivery note as proof of purchase).
Faults covered by warranty shall be eliminated by re-
placement or repair. Damage caused by improper op-
eration of the gun is not covered by warranty.
Claims under warranty shall only be considered, if the riv-
et gun is returned fully assembled to a WÜRTH agency,
your WÜRTH sales representative or a customer service
workshop for electrical equipment authorised by WÜRTH.
The metal saw conforms to the current EMC stand-
ards.
It has been tested according to EN 61000-6-1,
EN 61000-6-3, EN 55014-1 and EN 55014-2.
The measured values conform to UNI EN ISO
3746-1997.
Typical measured noise levels (A):
Noise level
Without load, band speed
80 m/min
With load, band speed
80 m/min
(cutting steel Ø 80mm)
Noise level
Without load, band speed
80 m/min
With load, band speed
80 m/min
(cutting steel Ø 80mm)
We herewith declare that this product conforms to the
following standards and directives:
EN 55014-1, EN 55014-2, EN 61000-6-1, EN
61000-6-3, 2004/108/EC and 2006/42/EC.
07
Adolf Würth GmbH & Co. KG
Subject to changes without prior notice
Electromagnetic compatibility (EMC
Noise/vibration
•
The hand-arm vibration is typically lower than
2.5 m/s²
Declaration of Conformity
L
= 71.2 dB(A)
pm
L
= 87.0 dB(A)
wa
L
= 86.3 dB(A)
pm
L
= 102.1 dB(A)
wa
L
= 68.8 dB(A)
eq
L
= 83.1 dB(A)
eq
19
Publicidad
