Beko BHCA66641BBHS Manual Del Usuario página 15

If the ambient temperature differ-
ence occurs even when the hob is
not operating while the automatic
mode is active, the temperature
sensor in the product will detect
the difference and the product may
start operating at Speed 2 or 3 de-
pending on the difference. In this
case, automatic mode will be
turned off when the temperature
difference is equalized.
Do not use automatic mode when
your hob is not working.
Air cleaning mode (for models B and C)
You can use air cleaning mode to eliminate
the odour in your house during a long time
at low level.
1. Touch the Speed 1 key for more than 3
seconds.
ð Air cleaning mode is activated.
The light of the Speed 1 key
flashes when the air cleaning
mode is active.
2. The air cleaning mode will operate at
Speed 1 for 10 minutes in 1 hour and
will stop for 50 minutes. If you do not
switch off the air cleaning mode, it will
remain in operation for 10 minutes, then
stop for 50 minutes in each hour for 24
hours.
When air cleaning mode is active, it
is automatically cancelled at the
touch of any key except lamp key.
Your hood continues to operate at
the function of the key you touch.
Aluminium filter fill warning
The light of Speed 2 key flashes after every
100 hours of operation. In this case, you
must clean your aluminium filter. After
cleaning, the lamp warning of Speed 2 but-
ton does not turn off automatically. When
you touch the Speed 2 key for more than 3
seconds, aluminium filter fill warning is re-
set and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes after every
100 hours of operation. In this case, you
must replace your carbon filter. Consult an
authorized service for this. After replace-
ment, the lamp warning of Speed 2 key
does not turn off automatically. When you
touch the Speed 2 button for more than 3
seconds, carbon filter fill warning is reset
and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again.
EN / 15
EN
DE
PL
ES