ResMed Stellar 100 Guia Del Usuario página 16

Starting therapy using oxygen
1
Fit the oxygen connector to the oxygen inlet of the device.
2
Attach the other end of the oxygen supply tubing to the oxygen supply.
3
Press
4
Turn on oxygen.
Stopping therapy using oxygen
1
Turn off oxygen.
2
Press
Using the FiO
Use of the FiO
CAUTION
Do not use the FiO
Preparing to use a new sensor
1
Before use, leave the FiO
2
Attach a new FiO
3
Perform the sensor calibration (see "Setup menu" on page 16).
Note: The FiO
8
1
to start treatment.
to stop treatment.
monitoring sensor
2
monitoring sensor may be recommended by your clinician.
2
monitoring sensor with the H4i humidifier.
2
monitoring sensor open to the air for 15 minutes.
2
monitoring sensor (as shown below).
2
monitoring sensor must be replaced every 12 months.
2
3
1
2
4
2
Oxygen
supply
1
2
Press spring to release
connection after use
5