Andis DBLC-2 Instrucciones De Uso Y Cuidado página 4

16. WARNING: Never touch both terminals on clipper with
metal objects and/or body parts, as short circuit may
result. Keep away from children. Failure to comply with
these warnings could result in fire or serious injury.
17. This appliance is intended for trimming purposes only.
18. WARNING: For the purposes of recharging the battery,
only use the detachable supply unit provided with
this appliance.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
- The battery must be removed from the appliance before it is recycled.
- The battery is to be recycled as a lithium-ion battery.
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter.
3. Connect the power cord to the back of the charger and then insert the transformer
into an AC outlet.
CHARGING UNIT
To charge, plug wall adapter into 100-240V, 50/60 cycle AC electrical outlet or as
noted on the unit. Make sure the proper input plug is attached to the wall adapter.
Plug power cord directly into back of charging stand. The battery pack may be
charged while on the clipper or separately. To charge the battery pack while in the
unit, place clipper into the pocket on the charging stand. NOTE: the clipper should
be charged with the switch in the OFF position. To charge the battery pack separately,
remove the battery pack by pressing the tab on the back of the battery (Figure A),
sliding the battery out and placing in the pocket on the charger (Figure C).
Before using your clipper for the first time, make sure the battery has been fully
charged. Note that it is normal for the clipper and wall adapter to feel warm to
the touch when charging. This is especially true if the battery has been deeply
4