Dometic COOLAIR RTX 1000 Instrucciones De Montaje página 12

Installation
7.6 Fitting the unit in the roof hatch
!
CAUTION! Risk of injury
Only install the unit in support of e. g. second person, crane, working platform.
The work safety must be guaranteed at all times.
➤ Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig. 0).
I
NOTE
Once the unit is in position on the vehicle roof, the seal should make contact all
the way round. Only then can a reliable seal be achieved.
➤ Position the fixing brackets underneath the cab roof (fig. a).
When doing so, slide the fixing brackets between the cab roof (chassis) and
the roof lining (if existing).
A
NOTICE! Damage hazard
The fixing brackets must be positioned on a firm base since they will brace the
unit against the cab roof. The contact area of the fixing brackets must be at least
40 mm on all sides.
A
NOTICE! Damage hazard
Do not exceed the specified tightening torque under any circumstances. That
is the only way to ensure that the threaded plugs are not pulled out.
➤ Fix the parking cooler in place as illustrated (fig. a).
➤ Establish the required length of the M8 hexagon-head screws as follows:
Screw length = Distance between bottom edge of fixing bracket and bottom
edge of unit plus 5 – 9 mm.
If necessary, shorten the hex-head screws to the size determined.
12
CoolAir
EN