Dometic COOLAIR RTX 1000 Instrucciones De Montaje página 5

CoolAir
• Please inform your vehicle manufacturer if the height entered in your vehicle
documents needs to be altered due to the installation of the parking cooler.
– RTX1000/2000 height: 175 mm
– SPX1200T height: 60 mm
• Disconnect all power supply lines when working on the parking cooler
(cleaning, maintenance, etc.).
2.2 Handling electrical cables
A
NOTICE!
Damage hazard
• Use cable ducts to lay cables through walls with sharp edges.
• Do not lay loose or bent cables next to electrically conductive materials
(metal).
• Do not pull on the cables.
• Attach and lay the cables in such a manner that they cannot be tripped over
or damaged.
• The electrical power supply may only be connected by a specialist work-
shop.
• The connection to the vehicle's electrical system should be protected as
follows:
– Power supply: RTX 24 V: 40 A; RTX 12 V: 80 A
– Voltage monitor: 2 A
• Never lay power supply lines (battery leads) in the vicinity of signal or control
cables.
3 Target group
The mechanical and electrical installation and setup of the device must be per-
formed by a qualified technician who has demonstrated skill and knowledge
related to the construction and operation of automotive equipment and installa-
tions, and who is familiar with the applicable regulations of the country in which
the equipment is to be installed and/or used, and has received safety training to
identify and avoid the hazards involved.
4 Intended use
The parking cooler is used to supply the interior of the driver cab with cool and
dehumidified air.
The parking cooler is designed for stationary use. It can be used while driving.
EN
Target group
5