Kroger BP3NP1-3EKRO Manual De Instrucciones página 22

1. To set an alarm time, press the time button (the
instrument must have been switched off beforehand)
and immediately afterwards the "M" button and hold
both down until the bell symbol appears in the bottom
left of the display. Then release both buttons. The
flashing "1" in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hours dis-
play flashes and pressing the "M" button allows you to
set the alarm hour. To confirm, press the time button.
3. The minute display will now flash. The minutes can be
set using the "M" button. To confirm, press the time
button again.
4. The bell symbol will now flash. Use the "M" button to
select whether the alarm time is to be active (bell) or
inactive (crossed-out bell). To confirm, press the time but-
ton.
To set a second alarm time, proceed as above but if the
"1" flashes, press the "M" button to select "2" and con-
firm with the time button.
• An active alarm time is indicated by the bell symbol in
the display.
• The alarm sounds at the set time every day.
• To switch-off the alarm when it is sounding, press the
START/STOP button.
• To permanently switch-off the alarm, proceed as above
(steps 1-4) and select the crossed-out bell symbol.
This will then disappear from the display.
• The alarm times must be re-entered each time the
batteries are replaced.
21