Publicidad
Idiomas disponibles
Idiomas disponibles
Brake Caliper Bleeding Valves | 1/4" & 1/8" NPT
COMPONENTS
1 Twist drill, 6.0 mm, HSS
2 Twist drill, 8.5 mm, HSS
3 Milling tool, 11 mm, titanium nitrated
4 Hand tap, 1/4"x18 NPT, HSS
5 Countersink, 13.4x90°, HSS
6 Hand tap, 1/8"x27 NPT, HSS
7 Bleed valve insert: 1/4" NPT (x2)
8 Bleed valve insert: 1/8" NPT (x2)
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This Repair Set is using for boring out demolished bleeding valves.
During the repair, the complete valve including the thread is drilled out, a new thread is made and
replaced by a threaded bush with a new bleeding valve.
This repair kit is suitable for many vehicle types e.g. Audi, VW, Opel, etc.
SAFETY INFORMATIONS
•
Keep children and other persons out of the working area.
•
Do not allow children to play with this tool or its packaging.
•
Make sure that the work area is sufficiently illuminated.
•
Keep the work area clean, organised, dry and free from other materials.
•
Do not allow untrained persons to work with this bleeding tool.
•
Always wear eye protection when working with this tool.
•
Always use new brake fluid from sealed container when bleeding hydraulic brake system.
•
Always observe the vehicle manufacturer's instructions. Use brake fluid approved by the
vehicle manufacturer only.
•
Never operate vehicle if you are in doubt of the effectiveness of the braking system. Drive the
vehicle only when brake pedal has a clearly defined pressure point and all components have
no leaks.
•
Repairing of brake systems should be carried out by a trained person.
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in damage and personal injuries.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Universal Repair Set | for
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9346
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
