Emos P5733W Manual De Instrucciones página 3

GB | Wireless Doorchime
The set consists of a doorbell button (transmitter) and a chime (receiver). The
chime is designed for constant connection to a 230 V AC/50 Hz power grid.
Transmission between the button and the chime is carried via radio waves at
a frequency of 433.92 MHz. The range depends on local conditions and reaches
up to 150 m in an open area without interference.
The set has a so-called self-learning function – the button is able to generate its
own pairing code which is then received by the chime and stored in its memory.
The set can thus be expanded with additional buttons. The self-learning function
also prevents the set from affecting neighbouring doorbells.
For proper usage of the wireless doorbell, read the instruction manual
thoroughly.
Technical Specifications
Transmission range: up to 150 m in an open area (can drop down to one fifth
in a busy area)
Button: water resistant; IP44 enclosure rating
Pairing the chime with buttons: self-learning function
Pairing capacity: maximum of 8 buttons per 1 chime
Number of ringtones: 36
Transmission frequency: 433.92 MHz, 10 mW e.r.p. max.
Chime power supply: 230 V AC/50 Hz
Button power supply: 1× 3 V battery (type CR2032, included)
Includes: double-sided adhesive tape, screws
Chime Description (see fig. 1)
1 – bell LED
2 – volume setting button
3 – ringtone change button
Button Description (see fig. 2)
1 – ring button and LED
2 – battery compartment/mounting pad
3 – hole for opening the battery cover
4 – battery
Installing the Button /Removing the Mounting Pad (see fig. 3)
1 – mounting pad
2 – holes for screws
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver into the
hole on the bottom.
Insert a 3 V type CR2032 battery into the button. When inserting a battery,
make sure to observe the correct polarity! Replace the battery cover.
3