Publicidad
Idiomas disponibles
Idiomas disponibles
Gearshift:
1. Move the gas lever all the way to the right.
2. Release the clutch lever to disengage.
3. Move the shift lever to the desired gear position.
NOTE: If the gear lever does not engage the desired gear, tighten
the clutch lever and slightly move the axle to reposition the gears.
4. Tighten the clutch lever
5. Select the speed
The tiller has three speeds to choose from:
Conversion of speeds:
(1) Set the throttle to the right.
(2) Release the clutch handle and let the
clutch release.
(3) Set the shift lever to the desired speed.
(4) Pressing on the clutch handle, the
engine moves to the new speed.
FAST - NEUTRAL - SLOW
6. Front wheel
Use the front wheel to move the tiller on the road. Lift the handle-
bar and lower the wheel until it touches the ground.
WARNINGS:
- Do not use the tiller with blades that had a diameter greater than
300 mm.
- Sloping use can cause the machine to overturn.
- Use by untrained personnel can cause serious injury.
- Wear tight protective shoes. Use with bare feet or with open
shoes or sandals may increase the risk of injury.
- Do not use the tiller at night.
- The transport of the tiller from one place to another must be
carried out with two operators without the aid of a means of trans-
port.
- If the blades get blocked by mud, gravel, etc., immediately stop
the
engine and clean it in safe conditions. Wear protective gloves during
cleaning operations. Before the next use it is possible to verify that
the tilller has no signs of damage or other anomalous operations.
8. ENGINE SHUTDOWN
In emergency situations:
- Release the clutch to stop transmission
In normal use:
- Slow down, release the clutch lever and put the gear selector on
neutral position
7
EN
Publicidad
