Renfert MT premium Guia De Inicio Rapido página 8

Hazard and warning information
en
General information
► If the unit is not used in accordance with the supplied operating instructions, the intended safety
can no longer be guaranteed.
► The unit may only be operated using a power cord equipped with a plug appropriate to the local
power supply. Any necessary modifications must be carried out by a qualified electrician.
► Only operate the unit if the information on the nameplate corresponds to the specifications of
your local mains power supply.
► The unit may only be plugged into electrical sockets that are connected to the protective conduc-
tor system.
► The power plug must be easily accessible.
► Disconnect the unit from the mains power supply before carrying out work on the electrical parts.
► It is the responsibility of the operator to ensure that national regulations are complied with during
operation and regarding recurring safety inspection of electrical equipment. In Germany, these are
DGUV Regulation 3 in conjunction with VDE 0701-0702.
► Check connection cables (such as power cords), tubes and housing (such as the key pad) regu-
larly for damage (such as kinks, cracks and porosity) or signs of ageing.
Do not operate equipment with damaged connection cables, tubes or housing parts or other de-
fects!
► Defective equipment must be taken out of service immediately. Disconnect the power plug and
secure the equipment against further use. Send the equipment in for repair!
► Only operate the equipment under supervision.
► Please observe the national accident prevention regulations!
► Information on REACH and SVHC is available on our website at www.renfert.com, in the Support
area.
Specific information
► When working with the trimmer, do not wear loose or wide clothing and keep long hair tied back.
There is a risk of injury if these are pulled into or become entangled in the equipment!
► Never open the front cover while the motor is running. The startup protection does not cause the
grinding disc to stop.
► Only open the front cover after the grinding disc has come to a complete stop.
► Always wear protective goggles when grinding.
► Do not touch the trimmer disc while it is rotating.
► Do not work without the model table installed and locked into position ("click"). There is a signifi-
cant risk of injury from small parts or fingers becoming caught in the unit.
► Only lift the trimmer table when the disc is stationary.
Authorized persons
Operation and maintenance of the equipment may only be performed by trained personnel.
- 2 -