LIMIT DCM 2 Manual De Instrucciones página 6

POSITIONS (PICTURE 1)
GB
1. NCV sensing end
2. Clamp jaws
3. Hand guard
4. LED indicator
5. Jaw opening trigger
6. Functional dial
7. LCD display
8. Function buttons
9. Signal input jack +
10. COM input jack -
SYMBOLS
Symbol
CAT II
CAT III
BUTTON DESCRIPTION
1. SELECT button
Press this button to switch between the corresponding measurement functions;
in the AC/Hz position, short press this button to switch between the AC and Hz
measurement function.
2. MAX/MIN button
Short press this button to enter the maximum/minimum measurement mode
and long press to exit.
3. HOLD/BACKLIGHT button
Short press this button to enter/exit the data hold mode, and long press (about
2 s) this button to turn the backlight on/off (the backlight will automatically
turn off after 60 s).
4
Description
Caution, possibility of electric shock
Alternating current
Direct current
Equipment protected throughout by DOUBLE INSULATION or
REINFORCED INSULATION
Earth (ground) TERMINAL
Warning or Caution
Applicable to the testing and measuring of circuits connected
directly to utilisation points (socket outlets and similar points)
of the low-voltage MAINS installation.
Applicable to the testing and measuring of circuits connected
to the distribution part of the building's low-voltage MAINS
installation.
1
2
3
5 4
6
CLAMP METER DCM 2
8 7
9
10
Picture 1