Serial 1 MTN Manual Del Propietário página 17

Torque Specifications
Always tighten fasteners to the correct
torque to ensure the integrity of the
eBicycle. In case of a conflict between this
manual and information provided by a
component manufacturer, consult with
Serial 1 or the component's customer
service representatives for clarification.
Table 3: Torque Values
Tool
Part Torque
Size
4mm
Tighten bottom two,
Handlebar 6 Nm
⬡
then top two screws
Handlebar 4mm If necessary, for
6 Nm
⬡
stem service
Saddle rail 5mm If necessary, for
9 Nm
⬡
clamp service
Seatpost 4mm Set the height, then
6 Nm
⬡
clamp
Align brake disc
6mm rotor between brake
Rear axle 11 Nm
⬡
pads before
inserting axle
FIT
Verify your eBicycle is the correct size.
Correct fit is essential for a safe and
pleasant ride.
Front Suspension
SWITCH/MTN is equipped with a front
suspension fork that is delivered with a low
pressure setting to facilitate safe shipping.
Notes
The pressure setting in the front
suspension fork needs to be adjusted to
the proper level to match the rider
weight and ride style. Use either a
shock-pump (not included) or a floor
pump (Schrader valve) to adjust the
torque
pressure according to the following
table:
Table 4: Fork Pressures
WARNING
The above table is an approximation.
Reference the exact fork manufacturer's
operating methods or check at
www.Serial1.com
adjustment methods and pressure levels.
Rider Weight Fork Pressure
< 121 lb 35 – 50 PSI
[< 55 kg] [2.41 – 3.44 Bar]
121 – 143 lb 50 – 60 PSI
[55 – 65 kg] [3.44 – 4.13 Bar]
143 – 165 lb 60 – 70 PSI
[65 – 75 kg] [4.13 – 4.82 Bar]
165 – 187 lb 70 – 85 PSI
[75 – 85 kg] [4.82 – 5.86 Bar]
187 – 209 lb 85 – 105 PSI
[85 – 95 kg] [5.86 – 7.24 Bar]
209+ lb 105+ PSI
[95+ kg] [7.24+ Bar]
120 PSI
Max
[8.27 Bar]
for further details on
13