Noaton FORNAX Manual De Instrucciones página 29

6.2 SHADE INSTALLATION
- Align the protrusion of the cover with the notch of the mounting plate and rotate
clockwise to attach the cover
6.3 INSTALLING THE
BLADES
a) Remove the 6 blade screws from the bottom of the motor.
b) The blades are marked which direction to install them (THIS SIDE UP - this direction
up). Screw the blades to the bottom of the motor (see picture below).
6.4 LIGHT INSTALLATION
1. Remove the 3 screws from the triangular shaped light bracket. Use the
screws to attach the LED board to the triangular-shaped lamp holder.
2. Connect the connector to the LED module of the luminaire.
3. Fit the shade correctly onto the lamp plate. Then turn it clockwise. Make sure the lamp
shade is tightened.
Once the fan assembly is complete, you can plug in the electricity and start using the
ceiling fan.
29
EN