Bestway 53033 Manual Del Usuario página 2

6. Maximum mesh size for chain link fences should not exceed 1-3/4 inch
square unless the fence is provided with slats fastened at the top or the
bottom which reduce the openings to no more than 1-3/4 inches.
7. Where the barrier is composed of diagonal members, such as a lattice
fence, the maximum opening formed by the diagonal members should be
no more than 1-3/4 inches.
8. Access gates to the pool should comply with Section I, Paragraphs 1
through 7,and should be equipped to accommodate alocking device.
Pedestrian access gates should open outward, away from the pool, and
should be self-closing and have a self-latching device. Gates other than
pedestrian access gates should have a self-latching device. Where the
release mechanism of the self-latching device is located less than 54
inches from the bottom of the gate, (a) the release mechanism should be
located on the pool side of the gate at least 3 inches below the top of the
gate and (b) the gate and barrier should have no opening greater than 1/2
inch within18 inches of the release mechanism.
9. Where a wall of a dwelling serves aspart of the barrier, one of the
following should apply:
(a) All doors with direct access to the pool through that wall should be
equipped with an alarm which produces an audible warning when the
door and its screen, if present, are opened. The alarm should sound
continuously for a minimum of 30 seconds within 7 seconds after the
door is opened. Alarms should meet the requirements of UL2017
General-Purpose Signaling Devices and Systems, Section 77. The
alarm should have a minimum sound pressure rating of 85 dBA at 10
feet and the sound of the alarm should be distinctive from other
household sounds, such as smoke alarms, telephones, and door bells.
The alarm should automatically reset under all conditions. The alarm
should be equipped with manual means, such as touchpads or
switches, to temporarily deactivate the alarm for a single opening of the
door from either direction. Such deactivation should last for nomore
than 15 seconds. The deactivation touchpads or switches should be
located at least 54 inches above the threshold of the door.
(b) The pool should be equipped with a power safety cover which
complies with ASTM F1346-91 listed below.
(c) Other means of protection, such as self-closing doors with self-latching
devices, are acceptable so long as the degree of protection afforded is
not less than the protection afforded by (a) or (b) described above.
10. Where an aboveground pool structure is used as a barrier or where the
barrier is mounted on top of the pool structure, and the means of access is
a ladder or steps, then (a) the ladder to the pool or steps should be
capable of being secured, locked or removed to prevent access, or (b) the
ladder or steps should be surrounded by a barrier which meets Section I,
Paragraphs 1 through 9. When the ladder or steps are secured, locked, or
removed,any opening created should not allow the passage of a 4-inch
diameter sphere.
Section II: Barrier Locations
Barriers should be located so as to prohibit permanent structures, equipment
or similar objects from being used to climb the barriers.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set up on
uneven ground it can cause collapse of the pool and flooding, causing
serious personal injury and/or damage to personal property. Setting up on
uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud, sand,
soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones and
twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Assembly
Warning: Adult assembly required.
1. Take the pool and accessories out of the carton with care and spread out
the pool on to the selected site.
2. Open the safety valves and inflate the parts one by one. Be sure to close
the valves after inflation. Air pump is not included.
NOTE: Do not over inflate. Do not use either an air compressor or
compressed air.
3. Tie the slide to the pool with the provided ropes to the relevant grommets.
(For 53033, 53051, 53052, 53054, 91014, 53055, 53057, 53060, 53063,
91201, only）
4. Connect the Hose Adapter to the Hose Connector on the product.
(See Fig. 1)
5. Connect your garden hose to the Hose Adapter.
Note: The Hose Adapter can be used with two different garden hoses, see
Fig. 2 & Fig 3 for assembly.
Fig. 1
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
6. Slowly fill with water to pool just below the fill line on the pool's interior. Do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION: Do not leave pool unattended while filling with water.
Proper Water Level
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Empty the pool
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Deflate all the air chambers, at the same time push down the wall of the
pool to release the water. Make sure release all the water in 20 minutes.
NOTE: Drain by adult only!
Pool Maintenance
Warning: If you do not adhere to the maintenance guidelines covered herein,
your health might be at risk, especially that of your children.
• Change the water of pools frequently (particularly in hot weather) or when
noticeably contaminated, unclean water is harmful to the user's health.
• Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufacturer's instructions.
• Proper maintenance can maximize the life of your pool.
• See packaging for water capacity.
Cleaning and Storage
1. After use, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the product.
2. Air dry the pool, once pool is completely dry, fold pool carefully and put
back to its original packing. If pool is not completely dry, mould may result
and will damage the pool.
3. Store in a cool, dry place and out of children's reach.
4. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Repair
If a chamber is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
- La sécurité de vos enfants ne dépend que de vous ! Le risque est maximum
lorsque les enfants ont moins de 5 ans. L'accident n'arrive pas qu'aux
autres! Soyez prêt à y faire face!
- Surveillez et agissez:
• La surveillance des enfants doit être rapprochée et constante.
• Désignez un seul responsable de la sécurité.
• Renforcez la surveillance lorsqu'il y a plusieurs utilisateurs dans la
pataugette.
• Mouillez nuque, bras et jambes avant d'entrer dans l'eau.
• Apprenez les gestes qui sauvent et surtout ceux spécifiques aux enfants.
• Interdisez le plongeon ou les sauts.
• Interdisez la course et les jeux vifs aux abords de la pataugette.
• Ne Laissez pas de jouets à proximité et dans la pataugette qui n'est pas
surveillée.
• Maintenez en permanence une eau limpide et saine.
• Stockez les produits de traitement d'eau hors de la portée des enfants.
- Prévoyez un téléphone accessible près du bassin pour ne pas laisser vos
enfants sans surveillance quand vous téléphonez. Mais il ne remplacent en
aucun cas une surveillance rapprochée
2
Fig. 2 Fig. 3
Hose A Hose Adapter Hose B
Proper Water Level Proper Water Level
ATTENTION
Hose Adapter
S-S-005488