Master MT Pocket Manual De Uso Y Mantenimiento página 22

Disclaimers
Modifications to Master Products machines are prohibited without the manufacturer's approval.
Following unauthorised modification, the manufacturer declines any responsibility and cancels the warranty rights for
the machines to which modifications have been made. The manufacturer will not be responsible for any failures and
accidents that may result.
During the warranty period, Master Products machines must only be disassembled and repaired by the manufacturer's
technical staff or official representatives.
The operator who uses the machine must ensure that the crushed material is removed regularly, since the residues
can cause an obstruction and, therefore, a malfunction of the machine.
Transport
Electrical connection
The electrical connection of the MT Pocket machine is a single-phase 230 V/50 Hz electricity supply.
Placement
The MT Pocket must be attached to a work table with its anchoring system. Using the knob, fix it until it is securely
fastened as described in the section Assembling the MT Pocket.
It is only suitable for indoor use and under no circumstances should the electrical part be exposed to water and/or
humidity.
Start-Up
Assembling the MT Pocket
Attach the MT Pocket to the work support using the clamp and adjust the knob so that it is securely attached.
1
22
Box 31x38x28 cm = 7 kg / / Machine net weight = 5 kg
www.masterproducts.es