Publicidad
Idiomas disponibles
Idiomas disponibles
•
Inspect the test leads for damaged insulation or exposed metal. Check the test leads for
continuity. Replace damaged test leads with identical model number or electrical specifications
before using the Meter.
•
Do not apply more than the rated voltage, as marked on the Meter, between the terminals
or between any terminal and grounding.
•
The rotary switch should be placed in the right position and no any changeover of range
shall be made during measurement is conducted to prevent damage of the Meter.
•
When the Meter working at an effective voltage over 60V in DC or 30V rms in AC, special
care should be taken for there is danger of electric shock.
•
Use the proper terminals, function, and range for your measurements.
•
If the value to be measured is unknown, use the maximum measurement position and
reduce the range stop by step until a satisfactory reading is obtained.
•
Do not use or store the Meter in an environment of high temperature, humidity, explosive,
inflammable and strong magnetic field. The performance of the Meter may deteriorate after
dampened.
•
When using the test leads, keep your fingers behind the finger guards.
•
Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance, continuity, diodes, capacitance or current.
•
Before measuring current, check the Meter's fuses and turn off power to the circuit before
connecting the Meter to the circuit.
•
Replace the battery as soon as the battery indicator
Meter might produce false readings that can lead to electric shock and personal injury.
•
Remove test leads and multi-purpose socket from the Meter and turn the Meter power off
before opening the Meter case.
•
When servicing the Meter, use only the same model number or identical electrical
specifications replacement parts.
•
The internal circuit of the Meter shall not be altered at will to avoid damage of the Meter
and any accident.
•
Soft cloth and mild detergent should be used to clean the surface of the Meter when
servicing. No abrasive and solvent should be used to prevent the surface of the Meter from
corrosion, damage and accident.
•
The Meter is suitable for indoor use.
•
Turn the Meter power off when it is not in use and take out the battery when not using for
a long time.
•
Constantly check the battery as it may leak when it has been using for some time,
replace the battery as soon as leaking appears. A leaking battery will damage the Meter.
22
INTERNATIONAL ELECTRICAL SYMBOLS
appears. With a low battery, the
AC (Alternating Current)
DC (Direct Current)
Grounding
Double Insulated
Publicidad
