Specialized COMO Manual De Instrucciones página 39

Fig. 12.2
Unplug the cable from the enviolo AUTOMATiQ hub interface (A).
Remove both the rear axle nuts (B) and non-turn washers (C) using a 15 mm wrench.
„
Remove the wheel from the dropouts and remove the belt from the sprocket.
„
REMOVE THE REAR WHEEL (ENVIOLO MANUAL IGH)
12.3
Fig. 12.3
Flip the hub interface lever into the open position (A) and remove the lever and the barrel
„
out of the interface hooks (B).
Remove both the rear axle nuts (C) and non-turn washers (D) using a 15 mm wrench.
„
Remove the wheel from the dropouts and remove the belt from the sprocket.
„
INFO: See section 12.3 for the removal of the belt from the frame.
37
INSTALL THE REAR WHEEL
12.4
Fig. 12.4
If not already done, remove the rear axle nuts (A) and non-turn washers (B) from the axle
„
and hold the rear wheel up close to the dropout area.
Place the belt over the hub interface and onto the sprocket (C).
„
Place the rear wheel into the dropout.
„
INFO: Make sure that neither the AUTOMATiQ connector nor the cable is
crushed or kinked.
TECH TIP: In some cases, it is helpful to remove the chain/belt from the front
chainring to simplify the assembly of the rear wheel.