Replacing The Filters; Replacing The Flow Rate Regulator - Franke AQUA741 Instrucciones De Montaje Y Uso

18. Replacing the filters

Water volume regulator filters
18.1 Close the water volume regulators (see
18.2 Unscrew the locking screws (a) on the water volume regulators.
18.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
18.4 Reassemble in reverse order.
19. Cleaning the shower head faceplate
19.1 Release the screw using an Allen key.
19.2 With a screwdriver, carefully lever out the spray faceplate.
19.3 Clean the shower head faceplate.
19.4 Reassemble in reverse order.

20. Replacing the flow rate regulator

20.1 Release the grub screw with an Allen key.
20.2 Pull the shower head out of the connection spigot.
20.3 Remove the locking ring on the inside using appropriate pliers for locking rings.
20.4 Pull out the flow rate regulator using flat-nosed pliers.
20.5 Replace the flow rate regulator. Observe the table.
Flow rate
0.15 l/s (orange)
0.20 l/s (red)
☞
Important!
Note the installation position of the flow rate regulator. The struts must point towards
the shower head.
20.6 Insert the flow rate regulator and secure with the locking ring.
a: Struts
b: Direction of flow
20.7 Slide the shower head onto the connection spigot.
20.8 Tighten the grub screw with an Allen key.
10
Work step 16.1).
Flow rate regulator
FAR-Best.-Nr. 2000104782
FAR-Best.-Nr. 2000104783