Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE POLE SAW ATTACHMENT TO THE POWER HEAD
This pole saw works as a combination of the pole saw attachment and the power head
(Fig. 7a).
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
The pole saw attachment connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Align the arrow on the pole saw shaft with the arrow on the coupler and push
the pole saw shaft into the coupler until you hear a clear "click" sound which
indicates the pole saw shaft is mounted into place (Fig. 7b).
4. Pull the shaft of the attachment to verify it is securely locked into the coupler. If not,
rotate the pole-saw shaft from side to side in the coupler until it snaps into place.
5. Tighten the wing knob securely.
WARNING:
equipment; check it periodically for tightness during use to avoid serious personal injury.
7a
Pole Saw Attachment
7b
18
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
Never attach or adjust any attachment while the power head is
Be certain that the wing knob is fully tightened before operating the
Wing Knob
Arrow on the Pole
Saw Shaft
Power Head
Shaft Release Button
Arrow on the
Coupler
Publicidad
