Ego Power+ PS1000 Manual Del Operador página 33

WARNING:
speed during cutting, which may result in severe motor damage.
WARNING:
WARNING:
injury.
Top Plate Sharpening Angles
(Fig. 25)
◾
CORRECT 30°- This optimal angle
can be obtained only when the
specified files and proper setting
are used. File holders are marked
with guide marks to align the file
properly to produce the correct top
plate angle.
◾
LESS THAN 30°- The tooth is too dull for cutting.
◾
MORE THAN 30°- The edge of the cutting tooth is feathered and dulls quickly.
Side Plate Angle (Fig. 26)
◾
CORRECT 65° - The optimal angle
can be produced automatically if
the correct diameter file is used in
the file holder.
◾
HOOK - "Grabs" and dulls quickly.
Increases potential of KICKBACK.
Results from using a file with a
diameter that is too small, or a file
held too low.
◾
BACKWARD SLOPE - Needs too much feed pressure, causes excessive wear to
bar and chain. Results from using a file with a diameter too large, or a file held
too high.
A dull or improperly sharpened chain can cause excessive motor
Improper chain sharpening increases the potential of kickback.
Failure to replace or repair a damaged chain can cause serious
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
25
Top Plate Sharpening Angles
LESS THAN 30°
30°
CORRECT INCORRECT
26
Side Plate Angle
Hook
65°
CORRECT INCORRECT
MORE THAN 30°
INCORRECT
Backward Slope
INCORRECT
33