Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
Motor does not
run.
Motor runs, but
chain does not
rotate.
36
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
CAUSE
◾
The battery pack is not
attached to the pole saw.
◾
No electrical contact between
the saw and battery.
◾
The battery pack charge is
depleted.
◾
The lock-off button is not
depressed before pressing
the trigger switch.
◾
The battery pack or power
head is too hot.
◾
Saw chain is bound in the
wood.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
Chain does not engage drive
sprocket.
SOLUTION
◾
Attach the battery pack to the pole
saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press and hold the lock-off button,
then depress the trigger switch to
turn on the pole saw.
◾
Allow the battery pack or power
head to cool until the temperature
drops to the recommended operating
temperature range.
◾
Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the pole saw.
◾
Press the saw chain against the
wood, move the pole saw back and
forth to discharge the debris.
◾
Remove battery pack, then remove
side cover and clean out debris.
◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.
Publicidad
