Descargar Imprimir esta página

Ego Power+ PS1000 Manual Del Operador página 28

Publicidad

Idiomas disponibles

Idiomas disponibles

LIMBING AND PRUNING
This pole saw is designed for trimming small branches and limbs up to 8" (200mm) in
diameter. For best results, observe the following precautions:
1. Plan the cut carefully. Be aware of the direction in which the branch will fall.
WARNING:
under the branch being cut.
2. The most typical cutting application is to position the unit at an angle of 60° or
less, depending on the specific situation, as shown in Fig. 19. As the angle of the
pole saw shaft to the ground increases, the difficulty of making the first cut (from
the underside of limb) increases.
3. Remove long branches in several stages.
4. Cut lower branches first to allow the top branches more room to fall.
5. Work slowly, keeping both hands on the saw with a firm grip. Maintain secure
footing and balance.
6. Keep the tree between you and the chain while limbing. Cut from the side of the
tree opposite the branch you are cutting.
7. Do not cut from a ladder; this is extremely dangerous. Leave such operations for
professionals.
8. Do not make the flush cut next to
the main limb or trunk until you
have cut off much of limb to reduce
the weight. Following proper cutting
procedures will prevent stripping the
bark from the main member.
9. Do not use the pole saw for felling
or bucking.
10. To prevent electrocution, do not
operate within 50 ft. (15m) of overhead electrical lines (Fig. 19).
11. Keep bystanders at least 50 ft. (15m) away (Fig. 19).
28
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
Branches may fall in unexpected directions. Do not stand directly
19
Minimum
Minimum
50' (15m)
50' (15m)
60°
60°
Maximum
Maximum

Publicidad

loading

Este manual también es adecuado para:

Ps1000-fc