Ego Power+ PS1000 Manual Del Operador página 37

PROBLEM
Pole saw does
not cut properly.
Bar and chain
run hot and
smoke.
CAUSE
◾
Insufficient chain tension.
◾
The bar and chain are
skewed and not parallel to
the housing.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
◾
Chain cutters are dull.
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
SOLUTION
◾
Loosen the quick chain-tension
adjust knob at least one turn
counterclockwise first and then fully
tighten it clockwise until the chain is
correctly tensioned.
◾
Remove the battery pack and reinstall
the bar and saw chain according to
the section "REPLACING THE BAR
AND CHAIN". Always remember to
keep the bar and chain parallel to
the mounting surface with one hand
before installing the side cover.
◾
Sharpen the chain cutters, following
the section "HOW TO SHARPEN THE
CUTTERS".
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and replace
the chain following the section
"REPLACING THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.
◾
Sharpen chain cutters by following
the section "HOW TO SHARPEN THE
CUTTERS".
37