Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE EXTENSION
POLE BETWEEN THE POWER
HEAD AND THE POLE SAW
ATTACHMENT (Model #EP1000
Sold Separately)
WARNING:
any attachment while the power head
is running or with the battery installed.
Failure to stop the motor and remove the
battery may cause serious personal injury.
This extension pole is designed to only be used with EGO PS1000/PS1000-FC. Never
use it with other EGO attachments.
The extension pole increases the machine length by 3.28 ft (100cm), extending the
cutting range. It should be connected between the pole saw attachment and the power
head. A maximum of two extension poles can be used on one machine.
Follow the process in the section "CONNECTING THE POLE SAW ATTACHMENT TO
THE POWER HEAD" to install the extension pole between the pole saw attachment and
power head (Fig. 8).
NOTICE:
Once assembled correctly, the pole saw attachment, extension pole and the
power head should not separate when pulled. Always test the connection by pulling
them. Repeat the steps above if the pieces can be separated during test .
WARNING:
instructed above could result in serious injury or death.
REMOVING THE POLE SAW ATTACHMENT FROM THE POWER HEAD
1.
Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3.
Press the shaft release button and, with the button depressed, pull or twist the
pole saw shaft out of the coupler to separate it from the power head or the
extension pole (if used).
4.
Repeat the process to separate the extension pole from the power head (if
extension pole is used).
Never attach or adjust
Failure to secure the attachment and power head/extension pole as
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
8
Coupler on the
Extension Pole
Extension Pole
Coupler on the
Power Head
19
Publicidad
