auna Patagonia DAB+ Manual De Instrucciones página 35

CHARGING YOUR SMART PHONE OR PORTABLE
DEVICE
The unit is in standby or power off mode.
This unit features a USB port for charging your portable device (iPod,
iPhone, Android phone, etc.) When used with the USB charging cord that
came with your device.
1. Fully charge the built-in rechargeable lithium battery prior to attaching
the device to be charged.
2. Plug one end of the USB cable (not included) into the USB port located
on the side of unit, Plug the other end of the cord into the device you
wish to charge.
3. Observe the battery charge indicator on your device and the charging
will start immediately.
4. It is recommended that you fully charge the internal Li-ion battery prior
to attempting to charge a mobile device with the USB port. The USB
port is only capable of delivering the amount of power that is left in the
internal Li-ion battery.
5. Unplug the cable when your device is charged or when the internal Li-
ion battery of the is drained.
CAUTION:
Before charging, please refer to the user manual of the device you wish to
charge to make sure the charging current required does not exceed 1Amp
(1,000 mA) of charging current. Overloading the charge circuit may cause
damage .
Notes:
1. Some smart phones and portable devices use proprietary USB
connections and circuitry, so they may not charge when plugged into
the USB port. Please refer to your device user manual before you
attempt to charge them.
2. It is normal for the product to be warm while the USB port is in use and
charging your smart phone or portable device.
3. The unit will switch to from charging mode to standby mode
automatically if internal Li-ion battery is drained.
4. After removing the external device you attached to product for
charging, wait for 10 – 15 seconds before powering on the unit.
5. In some cases, the internal battery may not fully charge your portable
device. It's recommended that if you start to get intermittent charge
indications, unplug the device and fully recharge the internal battery
EN
35