Publicidad
Idiomas disponibles
Idiomas disponibles
• No additional operation/setting is required in order to operate the appli-
ance at the rated frequencies.
• The appliance must not be installed behind a decorative door in order to
avoid overheating.
• The oven can be located high in a column.It is not recommended to in-
stall the oven under cooktop.If this is necessary,be sure to leave a large
enough gap for the cooktop according to the manufacturer's instruc-
tions. Before fixing,you must ensure good ventilation in the oven space
to allow proper circulation of the fresh air required for cooling and pro-
tecting the internal parts. Make the openings specified on last page ac-
cording to the type of fitting.
ELECTRICAL WARNINGS
• If the oven is provided by the manufacturer without plug:
THE APPLIANCE MUST NOT BE CONNECTED TO THE POWER
SOURCE USING PLUG OR SOCKETS, BUT MUST BE DIRECTLY CON-
NECTED TO THE SUPPLY MAINS. The connection to the power source
must be carried out by a suitably qualified professional. In order to have
an installation compliant to the current safety legislation the oven must
be connected only placing an omnipolar breaker, with contact sepa-
ration compliant to the requirements for overvoltage category III, be-
tween the appliance and the power source. The omnipolar breaker
must bear the maximum connected load and must be in line with cur-
rent legislation. The yellow-green earth cable should not be interrupted
by the breaker. The omnipolar breaker used for the connection must be
easily accessible when the appliance is installed. The connection to the
power source must be carried out by a suitably qualified professional
considering the polarity of the oven and of the power source. The dis-
connection must be achieved incorporating a switch in the fixed wiring
in accordance with the wiring rules.
• If the oven is provided by the manufacturer with plug:
The socket must be suitable for the load indicated on the tag and must
have ground contact connected and in operation. The earth conduc-
tor is yellow-green in colour. This operation should be carried out by a
suitably qualified professional. ln case of incompatibility between the
socket and the appliance plug, ask a qualified electrician to substitute
EN 7
Publicidad
