Simu T5 ZSP Manual Del Usuario página 2

COMPATIBLE TRANSMITTERS
3
1: 1/5 channels Wall Hz transmitter/ Memory Hz
2: 1/5 channels Mobile Hz transmitter
3: Color Multi 16 transmitters
4: Windy Hz Accel
Location of the PROG key on Hz transmitters:
Do not position the transmitter near metal in
order to avoid reduced range.
SET UP
4
If the installation includes several motors, power only 1 motor at a time to prevent cross programming
(4.1).
4.1- Factory mode:
a- Connect the motor to the power supply.
b- Press simultaneously on the « UP » and « DOWN »
buttons of a Hz transmitter. The motor will jog (turns
0.5 second in one direction and then in the other).
- Pressing the UP or DOWN button for less than 2 sec will move the motor in constant pressure mode.
- If you hold the UP or DOWN button for more than 2 sec the motor will move automatically in the UP or
DOWN direction. You will then have to stop the motor at the desired end-limit position by pressing the
STOP button. Go to section 4.2.
4.2 Checking rotation direction
a
b
Press on the « UP » button on the transmitter:
a- If the tube turns in the UP direction, go to section 4.3.
b- If the tube runs in the DOWN direction, reverse the rotation direction by pressing the « STOP » button for at
least 3 sec until the motor jogs. Confirm that the new rotation direction is now correct. Go to section 4.3.
US
2/12
1
1
OK § 4.3
3 s
(12 transmitters max. / 3 sensors max. per motor)
2 3
2 3
ON
a- b-
4
4
§ 4.3