Simu T5 ZSP Manual Del Usuario página 3

4.3- End limit adjustment:
The procedure used to set the end limits depends on the equipment of the product (see table below):
*The setting Typ 3 is especially suitable for « ZIP screens » with a heavy load bar and a top stop.
SETTING 1: MANUALLY SETTING THE UP AND DOWN END LIMITS (Product with automatic bottom lock
system prohibited):
1
+
1- Press the « UP » button: the motor will run up automatically if the button is held for 2 sec. Stop the motor
« STOP » button at the desired limit.
2- If necessary adjust the position with the « UP » and « DOWN » buttons.
3- Press simultaneously on the « STOP » and « DOWN » buttons: the motor will run down.
4- When the motor reaches the desired Down end limit, press the « STOP » button.
5- If necessary adjust the position with the « UP » and « DOWN » buttons.
6- Press simultaneously on the « STOP » and «UP » buttons: the motor will run up. Press « STOP » button to
stop the motor (Optional).
7- Press 2s on the « STOP » button to confirm the settings, the motor jogs.
The operation is completed. Go to section §5.
End limit
setting typ.
1
2
3*
4
5
2 3
Product devices
Top stop Locking system at lower end limit
None Manual
-
-
- -
4 5
Heavy
load bar
Automatic
-
-
- -
-
-
6
-
-
-
-
7
2 s
US
3/12